Injection syringe mould

Generally, high-quality silicone should be selected, which meets the following characteristics (here, Hongye silicone is used as an example): 　　①The mold silicone rubber has good operating performance.　　 How to make silicone molds durable?　　 One is the choice of silicone raw materials.What is a silicone mold?　　

Silicone mold is a special mold glue for making handicrafts. The characteristics of silica gel are high temperature resistance, corrosion resistance, strong tear resistance, and high simulation accuracy. Before repairing the mold, according to the actual situation of the bad phenomenon of the silicone mold, a detailed analysis and research should be carried out, and the remedy method should be proposed after finding the cause of the mold defect. Therefore, it is necessary to repair the malfunctioning silicone molds. However, in the process of using silicone molds, failure forms such as collapse, deformation, wear, and even breakage often occur.　　

This simulation can test geometrical constraints and critical regions of overlapping motion between molds, parts, and material transfer devices.The complex mold used on the multi-station press must match the performance of the press, so a device called a trial press is needed to debug the mold and shorten the installation time..　　 During the stretching process, the blanking die that presses the sheet between the stretching ring and the blanking part is critical to the quality of the part forming. The optimal blank holder force depends on the geometry of the deep drawn part and its material properties.

Computer simulation of the forming process is extremely important. If the blank holder force of the polystyrene formwork Injection syringe mould is too small, wrinkles will be formed in the stretched part; if the blank holder force is too large, when the sheet material is low carbon steel, the material cannot be fully stretched and will be torn. In order to reduce the number of mold changes at least, most companies will process the parts on the multi-station press according to today's fully automatic Large-scale multi-station presses for plate parts require corresponding blanking and die technology to achieve good deep drawing functions. Under normal circumstances, it is economical to change the mold when the production batch of the same part is between 30,000 and 5,000.　　 The development of tool and mold technology is due to the application of computers, the adoption of new or improved materials, the improvement of lubricants and the integration of computer manufacturing

Megosztás a facebookon